How to insulate your electric water heater tank
Materials:
- Water heater blanket
- Scissors
- Duct tape
Steps:
- Turn off the electric water heater at the breaker panel.
- Measure the height of the water heater and cut the blanket to fit if necessary.
- Leave the top of the water heater open.
- Wrap the blanket around the water heater and temporarily tape it in place. Position the blanket so that the ends do not come together over the access panels on the side of the tank.
- Mark the areas, then cut holes where controls are located. For electric water heaters, there will be two panels on the side of the tank. Mark the area where the pressure relief valve and pipe are located. This will be a pipe that protrudes from the side of the water heater.
- Adhere the blanket. Be careful to line up the cut out areas and then tape it permanently in place.
- Turn the water heat back on.
Looking for additional savings? View our heat pump water heater incentive here.
November 2016