As a not-for-profit utility, Dawson PPD focuses on cost-effectively extending the life of its existing facilities while maintaining adequate levels of safety and reliability. Testing wooden poles helps the District ensure reliability and long life of its equipment, saving customers money in the long run.
Traditionally, pole testing involved a hammer for sounding, a shovel for digging around the base and drilling holes to test for decay. Today, Dawson PPD hires a contractor that uses a scientifically-based system called POLUX as a less-invasive and more accurate form of testing.
POLUX works by sending two, three inch long probes the size of an eight-penny nail into the base of the utility pole. This is the most vulnerable point where decay is most likely to occur on a pole. The probes measure resistance and moisture content of the pole. This information, along with the type of wood the pole is made of and how it was treated are run through a computer program with the pole’s GPS location recorded.
Typically, Dawson PPD uses a Southern Yellow Pine tree for its poles, which should have a resistance of 8,000 pounds per square inch when new. If the measurement falls below 50 percent of the recommended resistance, in this case 4,000 PSI, the pole is marked for replacement.
All of Dawson PPD’s poles are tested every 10 years on a rotating schedule with 10,000-11,000 poles tested annually.
OTHER NEWS
Between the lines: The cost of reliable power
By Gwen Kautz General Manager 308-324-2386 gkautz(at)dawsonpower.com Our customers have indicated that reliable power is a top priority. And who could blame them? Nobody likes to be without power. When I think about my daily activities, I’m not sure how I could be...
Dawson PPD rate increase to go in effect April 1
February 18, 2020 - Dawson Public Power District will have an average two percent rate increase across all rate classes effective April 1, 2020. The vote for approval was made at the Dawson PPD Board Meeting on February 12. The District has invested more than $135...
Q & A with Electrical Engineer, Cole Brodine
What kind of projects do you work on? Since we are a small utility, I work on a lot of different things. It includes line design, both distribution and transmission, regulatory requirements like our spill protection plan and PCB removal plan, evaluating line equipment...