As a not-for-profit utility, Dawson PPD focuses on cost-effectively extending the life of its existing facilities while maintaining adequate levels of safety and reliability. Testing wooden poles helps the District ensure reliability and long life of its equipment, saving customers money in the long run.
Traditionally, pole testing involved a hammer for sounding, a shovel for digging around the base and drilling holes to test for decay. Today, Dawson PPD hires a contractor that uses a scientifically-based system called POLUX as a less-invasive and more accurate form of testing.
POLUX works by sending two, three inch long probes the size of an eight-penny nail into the base of the utility pole. This is the most vulnerable point where decay is most likely to occur on a pole. The probes measure resistance and moisture content of the pole. This information, along with the type of wood the pole is made of and how it was treated are run through a computer program with the pole’s GPS location recorded.
Typically, Dawson PPD uses a Southern Yellow Pine tree for its poles, which should have a resistance of 8,000 pounds per square inch when new. If the measurement falls below 50 percent of the recommended resistance, in this case 4,000 PSI, the pole is marked for replacement.
All of Dawson PPD’s poles are tested every 10 years on a rotating schedule with 10,000-11,000 poles tested annually.
OTHER NEWS
Between the lines – 2020: Should we be thankful?
By Gwen Kautz General Manager 308-324-2386 gkautz(at)dawsonpower.com How many of us go about our daily lives, living in a vacuum of sorts? By vacuum, I’m talking about living/working/being in the same routine. Didn’t 2020 disrupt that? What’s there to be thankful for?...
4 ways to save energy in the kitchen
1. Cook with smaller appliances A toaster or convection oven uses one-third to one-half as much energy as a full-sized oven, according to the Department of Energy. 2. Unplug appliances that draw phantom energy load Some appliances may draw energy even when they’re not...
Ghost Towns: A look at the past
Buffalo County Buda Buda holds the distinction of being the oldest town in the county. The town was originally named Kearney. In 1872, the name was changed to Shelby because of its similarity to Kearney Junction, a town five miles distant. Later, a station in the...